Sometimes we hope to use the 3D printer to make some plastic parts in small quantities (dozens or hundreds). In this case, we need a device to automatically remove the 3D prints on the hot bed and print this part repeatedly, so that the 3D printer can realize unattended automatic repeated production. Automatic Repeat Printing Module is an upgrade kit for Z9 to meet this requirement.
The premise that the Automatic Repeat Printing Module can work normally is that the printed 3D prints can be easily separated from the printing platform after the printing platform is cooled. According to our test, if we were used the glass printing platform and properly set the printing height of the first layer, the prints (made by ABS, PLA+ or PETG filament etc.) can be easily separated from the glass printing platform after the glass is cooled to below 25℃.
The Automatic Repeat Printing Module is composed of Arm Drivers, lead screw fixing blocks, lead screws and Pushing-arm. It is installed between the hot bed and the hot end. The working process is that finished one print first, then cooling the printing platform, and then push the prints out of the printing platform with the Pushing-arm, and then print the next one repeatedly.
This item is a DIY Kits, you need to do intstallation, uploading firmware, debug etc., it is not recommended that you buy this item if you have no DIY experience, .
User guide: https://github.com/ZONESTAR3D/Upgrade-kit-guide/tree/main/Auto_Repeat_Printing
- 1x Left Arm Driver Assembly with limit switch(1).
- 1x Right Arm Driver Assembly with limit switch(2).
- 1x Drive board(3).
- 1x Pushing-Arm(4).
- 1x lead screws(5).
- 1x Lead Screw Fixing Blocks(6).
- 1 x 6Pin DuPont wire, 1 x 2Pin power wire with connector(7).
- 4 x M3x6 screws + 4x M3 Nylon pillar(8).